Custom Composite Bearings
Trade Shows/Conferences
International WorkBoat Show 2011
Ernest Morial Convention Center
New Orleans, LA
November 30 - December 2, 2011
Booth # 2655
www.workboatshow.com
OTC 2012
Reliant Center
Houston, TX
April 30 - May 3, 2012
Booth #2480 (co-exhibiting with American Industrial Plastics)
www.otcnet.org
Hydro Vision 2012
Louisville, KY
July 17 - 20, 2012
Booth #1515
www.hydroevent.com
In the News
Check out CIP Bearings featured in the June issue in the Bearing and Seal Technology's.
The suitability of HMI's greaseless bearing materials (manufactured by CIP Composites) for the BCH project was determined through inspection visits to the CIP manufacturing facility, by supplier quality management personnel and from Voith and BC Hydro, HMI said. Read full article on HydroWorld.com
By Roland Ralkenhern, Naritoshi Nakagawa, and David Havard
Hydro Review World December 2010 issue features technologies regarding the elimination of oil in hydro electric facilities by conversion of Kaplan Turbines from oil to water or air with self lubricating bearings.
Technologies for Eliminating Oil in Kaplan Turbines
Self lubricated trunnion bushings installed at Foster Dam. Scroll down to read about the installation and working with U.S. Army Corps of Engineer's Portland District.
CIP Composites featured in the International Water Power and Dam Construction Magazine: January 2010.
Read more about "Eliminating grease lines and fittings"
www.waterpowermagazine.com
CIP Composite bearings were installed on the Heceta Head Lighthouse
last Wednesdsay, May 20, 2009. Florida based company, Lighthouse Lamping was called in to remove the old, worn-out friction rollers and replace the bearings that had seized up in the wheels. These bearings were replaced with CIP Composites.
See the article in the Register Guard.
Columbia Industrial Products just celebrated
10 Years of CIP Composites!!
September 2008
